GUZEL GS-SMINI60 hd Receiver DUMP BIN (gx6605s)

A tested dump file from the GUZEL GS-SMINI60 receiver to fix the problem of the receiver stopping booting after a wrong update process. Or disconnecting the device from power during the update process or updating the receiver with a version that is not compatible with the GX6605s processor type or a damaged update file. The dump file also fixes any defect in the operating software file. The dump file is sent through the update via the USB flash drive from inside the device if it is working and has problems such as:

• The receiver spasms after a short period of time .

• Disappearance of satellites or frequencies from within the list.

•  Not searching for channels even though there is a satellite signal.

•  Some menus disappear in the main menu.

•  The frequency signal disappears even though there is a voltage on the tuner.

If the receiver stops on the red light or the word ON or boot appears on the display screen, it will be repaired with the same dump file in two ways, as follows:

Solve the on or boot problem with USB For gx6605s :

• We download the dump or update file from below.

•  We change the name of the downloaded file to GxRom. (G and R are capital letters)

• We go to the USB flash drive and create a new file called (Files), then put the GxRom (G and R is A  capital letters) file inside it.

•  We connect the USB to the receiver and it is completely turned off. 

• We connect the receiver to the 12 volt electrical current and at the same time press the OK button on the remote control with quick and intermittent presses.

• We will see on the small display screen the word update.

• We wait for the update to complete (about 5 minutes).

• The receiver can be turned on , or the word end can be written on the display screen.

• Then we disconnect the power and connect it.

Solve the on or boot problem for gx6605s using loader :

The GX6605s processor hardware loader can also be used to fix the ON or Boot problem on the receiver, but the process requires a Rs 232 cable with the driver and loader.

Solve the on or boot in GUZEL GS-SMINI60 receiver using Eeprom programmer:

 The dump file for the receiver is programmed using the EEPROM flash drive programmer in the event that all methods fail (updating via the USB key, as well as updating via the loader), and it remains the best and effective way to solve all problems with the receiver.

Therefore, the zaginfotech website provides you with dump files, software, and the latest tested updates. We believe that there is no device that cannot be repaired due to the absence of a dump or software for it.

Download GUZEL GS-SMINI60 hd firmware DUMP BIN 

Flach ic  : U8

File Size : 4MB