StarSat SR-7065HD firmware dump free download

The Dump file is Exclusive to the Starsat SR 7065 HD receiver main board. GS21200HG Processor "Gx6605s" which is one of the Receivers launched by Starsat in the market. This release came after the success Achieved by Previous versions of Receivers, Such as the Starsat HD 7060, due to its good technical and Technical Specifications, as well as the appropriate price, which makes it one of the Fiercest Competitors in the receiver Markets. We Present to you an exclusive software dump Pulled From a new, Pre-tested Device to solve the Booting Problem of the HD 7065 receiver and how to fix on or boot issus.

Starsat SR 7065HD, Exclusive Tested Dump Software.

The dump file fixes Several Problems with the starsat hd 7065 receiver "Gx6605s" due to a Defect in the Operating file, Including:

• The Starsat receiver Stopped on the red light.

• Starsat stops on or boot starsat ligo on the tv.

• Disappearance of satellites or frequencies from the channel search list.

• There is no pickup signal With 14 and 18 volts at the LNB output.

• Disconnect the power from the receiver during the update Process.

• Updating the device with a version that is not compatible with the same model.

• Frequent Disconnection and Connection of electrical current.

How to update the starsat sr 7065 hd receiver via USB Key.

If Your Starsat Processor Gx6605s receiver is Turned on or Booted, all You have to do is Follow the Following Steps:

1. We download the file and decompress it.
2. We change its name to GxRom (G and R are Capital Letters).
3. We create a file inside the usb  key Named "files" and put GxRom inside it.
4. Connect the USB key to the receiver and turn it off.
5. We connect the power by pressing the power Button Intermittently and Quickly.
6. We notice the word “Update” on the display screen. We Leave the device until it is complete and Reboots.

How to drag the dump file to the processor's Gx6605s receivers?

To pull a dump file from a Gx6605s processor and keep it as a backup, we follow the following steps:

• After turning on the receiver, we connect the USB key. Go to menu then usb.
• We enter the USB key, then enter the number: 0943128 from the remote control. 
• We wait about 20 seconds and the end message will appear on the receiver interface.
•  We go into the USB and we will find two files with the name of the device, which are the duplicate dump file.

File Size : 4 Mb 

Do not forget to visit our Youtube channel